My Shark vents...(one of them)

[GTiRsalter]

I won the vac pump i was bidding for on ebay £250, so i should see the end of the bubbles in the carbon fibre :lol:

Ian.

 

[angelo_444]

I always thought that the moulds would be the most difficult part to make out of the whole process.
Guess I was wrong.

Nice vents though

 

[GTiRsalter]

the mould takes some time to make (1 week)cause it reflects the product you produce.
Its just that carbon is very visual so the smallest bubbles can make it look poo,where as if you painted the finished item you can cover up any defects :roll:..............but who paints carbon stuff!

only takes a day from start to finish to make a CF vent if it comes out right.

Ian.