FAQ - Turbo - Nissan SR20DET, Garret T3/T4, HKS GT Series turbo info

Status
Not open for further replies.
E

Edd

Guest
123 gtir said:
thx for the info m8 as any one here had the HKS GTRS fitted here so i can pich there brain about it ##
any info would be cool '## :lol:
wot u wanna know, i had one on my 2.2
 

123 gtir

New Member
the cost
were did you get it fitted
and if you got any lag,,
when did the turbo kick in,,,,,

thank you m8 you are a star ## :lol:
 

Mr GTiR

New Member
Nikko

I have the Norris Design Roller Bearing Hyper Turbo (Version Two). I think it's based on the following spec but i may be worng:

GT2835: I believe that the following is the spec for this, but I could bewrong: 48,52, or 56 trim 71mm BCI-18C compressor in T-04E housing. 84 or 90 trim UHP turbine cut down from 60mm to 56.5 mm. .64 or .86 A/R turbine housing. Ball bearing center section.

where will i produce full boost with this tubby and what are your thoughts on it?
 
Status
Not open for further replies.
Top