Photo with inlet top removed

[messerant]

Does anyone happen to have a photo with just the top of the inlet plenum removed in situ?

I’m looking at options to do the front brake hoses and wondering if top removal will give me enough access!

cheers

 

[Cathode]

Is this what you were after?

 

[messerant]

Thanks, but that’s with rocker cover removed - it’s the top part of the inlet removed I was after, so I can see how much extra access it would give me to do the brake lines

thanks tho

 

[Cathode]

Ahhh, sorry. my bad, too early.

 

[messerant]

Ha no worries mate, again, appreciate the response all the same!

 

[stugtir300]

Don't listen to him he's blind as f**k,really old and a shirt lifter.

 

[Cathode]

Pay no attention to him, no one else does. He loves stalking me, he does.

 

[fubar andy]

Does anyone happen to have a photo with just the top of the inlet plenum removed in situ?

I’m looking at options to do the front brake hoses and wondering if top removal will give me enough access!

cheers

No, but if you can wait a week or so, my plenum will be removed so I can take some photos behind the engine if that helps?

 

[fubar andy]

Not sure if those are any good to you?

 

[messerant]

Thank you for sending those over, I was more so looking to see how much access I would have with just the top cover of the inlet plenum removed as I’m doing g the front brake lines.

however - I have completed the drivers side and fitted the replacement, and so far removed the passenger side ready to make the replacement and fit without having to remove the inlet at all!

so, I’m getting there!

currently looking at where everyone fits there IAT sensor when running stock intercooler as well! That’s on the list once I’ve done the front suspension refresh!

thanks again for following up on this most appreciated!