Installing poly engine mounts

Trondelond

Active Member
Rightyo, I've got a Powerflex engine mount that I'd like to install. I'm wondering if there are other clever ways of doing this as opposed to the way I've done bushes on my Honda;
Cut or burn out the rubber part, use a metal saw to get a couple of grooves in the "ring" that is left in the engine mount, and then whip out a chisel and hammer into the grooves I've cut to loosen the ring from the engine mount itself.
 
Thats the way I've done it in the past. When putting the new bushes in, leave them in the freezer for 30minutes or until nice and cold before putting them in, and then they just drop in alot easier.
 
Top