How to remove flywheel (this is not a how to...)

[steve963]

well went for the cheap option , got flywheel off, dropped it on my little finger, danm those things are heavy!

my comment: wont i overtighten the crank pully nut! didnt even move, can see why you needed a 4ft bar now

 

[pulsarboby]

spanner and a sharp couple of welts with a club hammer removes them;-)

 

[Keira]

the cheapo 24v nut gun has turned up 8), i will use it this week when putting channies box back on, see how many bolts it can snap, threads it can fook up :lol:

 

[pulsarboby]

yeah mine arrived today too, is your one a rolston by any chance?

 

[Keira]

dont know mate, it turned up at the distribution centre (old folks house) and i havn't been round to pick it up yet.

will go get it tomorrow

 

[Keira]

just had a look at the listing.

doesn't say what make it is but i do get 3 free impact sockets :lol: its german, has better torque and impacts than my £200 'taskmaster' jobbie, which if this one is anything like mikes, will probably never get used again :lol:

 

[pulsarboby]

yeah it will be a rolston then, mine said 3 free impact sockets but it came with 4!
will try it out tomorrow to see if its any good or a load of ol crap.

 

[Keira]

dont forget the batteries need a couple of charges before it'll be up to full strength

this is my cheapo badboy,

 

[pulsarboby]

yep same as one i got

 

[azboy]

yep have to say the dewalt impact gun is about as good as they get
never had a bolt it couldnt undo as yet (apart from a crank pulley bolt but that took a blow torch and 4ft scaffold poll lol)

the egalsomeram is the best but at 450 it should be

 

[azboy]

for price wise the sealy version is the best at 160 pounds plus vat and more power full then the snap on 18 volt gun.