clutch is always ON ? :(

A

Anonymous

Guest
even if i push left pedal in floor, i still cannot change gears.
i can change gear, when engine is stopped, but when i start engine (clutch is off, pedal in floor), car begin move (as if i have automatic gearbox)...

during drive, i can change gears only on 3000rpm, with clank...

whatthehell :cry:
 
D

Dee 1

Guest
As your clucth wears the bite gets lower down to the point where there`s no pedal left :)

I`d say you need a new clucth mate :cry:
 
J

jaygtir

Guest
is there fluid in you footwell under the clutch pedal?
if so, your master cylinder is fooked, mine went 2 weeks ago. :(
 
A

Anonymous

Guest
the level of fluid in white vessel under the hood is ok...
 
S

SunnyGTIR

Guest
See if you can get some adjustment on the master cylinder by the pedal.
 
A

Anonymous

Guest
what u mean?

PS now i'm changin gear without clutch. rally mode 8)
 
ki_saj_ng

ki_saj_ng

New Member
:D :lol:

cool, i think u need to adjust the biting point so that its driveable for now but realisticaly u need to do a clutch change.

someone here will point out on how to adjust the biting point.

saj 8)
 
P

Paul Firth

Guest
The biting point gets higher, not lower, as a clutch wears. Yours isn't actuating properly. It could be the hydraulic system at fault or the clutch fork. It could possibly be the clutch or release bearing but you'd most likely hear the bearing rattling then. You need to look at the slave cylinder and clutch fork while someone presses the clutch to see what's happening, and also try pumping the pedal a few times the same way you would with your brakes to see if it is an hydraulic fault.
 
A

Anonymous

Guest
i found the problem :)

pedal unit is broken, i need to dismantle pedals to weld..

need i disassemble all the dash?
 
You must log in or register to reply here.
Top