any good autoelectritons? in manchester area

[chrisyleigh]

As above, want to take out this stupid old apexi safc as its dodgy as hell sometimes the lights are all green on cold start revs at around 1500rpm , after the cold start drops to 900rpm and the lights on the safc are all green but when fully warmed up the revs are back to about 1100-1500 and what ever rev range the engines at the light goes red on which ever one. Cheers chris

 

[PobodY]

Can you not just trace the wires back and cut it out yourself? - The only real issue is working-out which wires were cut to install it, and rejoining them.

 

[geoff pine]

Can you not just trace the wires back and cut it out yourself? - The only real issue is working-out which wires were cut to install it, and rejoining them.

you could have told him that on sunday :lol:

 

[chrisyleigh]

Dont get the sunday bit and im honestly crap at wires i know if i unplug the thing it starts and runs/revs but as soon as u try to drive it bogs and dies

 

[PobodY]

Easy. - On Sunday we had the North West section meet in Haydock; it's just down the A580, less than half an hour from Stockport (and about 45 minutes from Crewe). If you'd come we'd have had a look at it for you and maybe seen what could be done then and there.

I got my "bent" chassis checked and OK'd that way (it was a bent wishbone, not a chassis leg).

Admittedly it was just the three of us this time, but we often get a good turn-out and when we do there's some valuable knowledge and experience on offer. - Plus if we know you're bringing problems to look at, people will bring tools and spares just in case.

 

[chrisyleigh]

OW SHIT ! I said i would come aswell totally forgot ! Fucking hell was looking forward to that but was so busy trying to sort out my mates corsa c'vxr and also serviced the pulsar i just forgot ! The meal thing was it a good turn out whens the next meet? Sorry boys !

 

[campbellju]

In case George's comment wasn't clear, AFC's normally intercept the wires so you have to find where to cut it out and solder the original wires back together again.