my pulsar is off on rollers next week!!

[Gav_Kara]

this is going to be the first time its been on rollers hoping for a good result i,ll be happy with 300+!!

just got to check all pipes oil water ect ect before it goes on!

when i got results next sat i,ll post um up and hopefully with a big smile!

 

[gtir_pimp]

whats the spec sunny jim? is it going to a dyno dynamics rolling road?

 

[Gav_Kara]

its going to corton-millers in lincolnshire on there dyno!!!
spec is....
HDI FMIC with samco pipe run
HKS SSQV bov
HKS air filter relocated on custom pipe
HKS acuator
GARRETT GT2871R turbo
nismo spark plugs
samco water pipes
FSE FPR running 3bar
blitz spec r boost controler
battery in boot
tubular mainifold
AP lightened flywheel
organic clutch
close ratio gearbox (been told its a dakar)?????
remapped standard ecu
mongoose system with 3inch down pipe and decat.
welbro 255 fuel pump

 

[gtir_pimp]

what psi/bar is the controller at? you should see well over 300 with that turbo and spec!

 

[Gav_Kara]

its a good turbo and i got the .86a/r one!!! when controller off it runs .8 bar my controller has 4 settings 1-4 is from 1 bar too 1.4 as long as it dont lean out i hoping for a good read out on dyno!!

 

[the chief]

might get 320 to 350 at 1.4

 

[Gav_Kara]

might get 320 to 350 at 1.4

hope so that,ll be nice

 

[olliecast]

good luck mate. was your ecu mapped with the 2871r on?

 

[sadsy]

Il post mine up too gav, should be a good day if i ever get my bloody rad sorted out!

 

[Gav_Kara]

good luck mate. was your ecu mapped with the 2871r on?

no mate it was mapped for hybrid turbo FMIC exhaust filter ect!!!
it runs well with it on and the mods but if it needs fine tuning i can soon get it done so all will be told next week when rollered!!!