z32 size?

[rossdj1983]

i need to get a reducer from my inlet to a z32 afm, so i need to know what the o/d is of the z32?

 

[stevepudney]

3" or 76mm

 

[johnsy]

i was gonna ask this question!

could some one in the know please confirm the silicone hose dia for the Z32,

i currently have a 76mm-63mm reducer to take the standard maf,

 

[johnsy]

 

[red reading]

z32 is 3" od

 

[johnsy]

so i should be able to just do away with the reducer and bung it in the end of the elbow(76mm)

 

[STU666V]

so i should be able to just do away with the reducer and bung it in the end of the elbow(76mm)

Aye it should go straight on ;-)

 

[red reading]

yarse you should

 

[skiddusmarkus]

Looking at your setup Johnsy I don't think you will be able to get enough of the MAF to get a good seal because of the bend, you can't clamp it as tight as your current coupler as the MAF is plastic and might crack.You might be lucky but it looks like you might need another bit of straight 3" silicon to do it.

 

[johnsy]

i was looking at that tonight, think ill just by another elbow, i had to that one down so it would all fit in lol, the reducer took up to much space