shimming... who and where?

soin

New Member
hi , i need to get my clearances adjusted .. the motors 500 miles in from a rebuild with jwt uprated cams and the top end is rattlin a good un .. need this doing asap and can travel .. anyone recommend anywhere /one
 

gtir_pimp

New Member
pulsarboby on here in southend but may be a while as hes quite booked up but give him a bell. where are you based?
 

olliecast

Active Member
i could do it in and around the nottingham area if required. did mine with pulsar bobbys help line and its so much better now
 
P

pulsarboby

Guest
by all means il do it for you soin, but fully booked till middle of january.
but before you start letting others tamper with that rebuild 'take a tip from me' and let the people that built the engine sort it out as it should not be noisy, so they have not done it correctly in the first place.
if you now let someone else loose at it then you will invalidate any warranty they have given you, so if the worst happens and engine blows up then you have nowhere to go other than sort it out yourself!
 
Top