seat brackets
- Thread starter tonywill
- Start date
There aren't many options if you want sliders:
I went with option 3. - I got the seat in a place that was right for me and bolted it down.
- Take them off the old seats and modify them for your new application (this requires drilling the welds out).
Unfortunately the standard seat sits inside the frame so you may end-up a little higher than you intended. - If you can find some, buy the Bride GTi-R specific frames. - They do exist, and they're a direct fit... but they're also like rocking horse teeth.
- Give-up on sliders and buy some generic bucket seat mounts (like OMP from somewhere like YBRacing on eBay). - You will still need to do some modifying to get them to fit; the mounting points are offset on one side to go over the exhaust tunnel.
I went with option 3. - I got the seat in a place that was right for me and bolted it down.
Makaveli_se7en
Member
Option 4: Import GTiR specific frames from New Zealand: http://www.nzkw.com/
I have one for the drivers side. I was going to sell it but have decided to keep it. These are very well made and pass the NZ equivalent of the MSA blue book.
I have one for the drivers side. I was going to sell it but have decided to keep it. These are very well made and pass the NZ equivalent of the MSA blue book.
Aren't those for a NZ domestic Pulsar? - I assume they fit if you've already bought some, but I can only see "N14 Pulsar" listed.
Makaveli_se7en
Member
I didn't look at the ones listed on the website tbh, but they do make GTiR specific frames, just need to contact them.