please can anyone help

[CHRIS_2010]

big big problems after reading the how to guide on one bar boost mod etc,, after reading it etc, i connected both pipes up together and didnt block the solenoid up went for a road test and i couldnt boost over 0.5 psi and asson as i put my foot flat the ignitian cut, so i put it back together the way it was before hand and now the vehicle wont boost properly same as before boost will go to .4/.5 then when my foot goes flat on floor ignitian cuts

please help has any1 got some vacumm pipe diagrams i can have as i need to sort it

help chris

 

[CHRIS_2010]

please` anyone

 

[geetee]

http://www.mummachummas.co.uk/gtir/BoostControls.gif


I think the way you are supposed to do the mod is pull pipe marked 8 off at the air inlet end and loop i round to the other side of the solenoid valve.

Pull pipe marked 6 off the solenoid and connect it to the air inlet from where you unplugged 8 as above.

Cheers
Graham

 

[CHRIS_2010]

opps, well ive put it back to how it was but now it wont boost properly before it cuts the ignitian

grrr

 

[CHRIS_2010]

i give up now, since ive had my r its been nothing but grief i dunno what to do now grrr