Next stage???

chopper

New Member
The mods I have so far are: Custom full 2.5inch exhaust (decated), FMIC, blow off valve, air filter, green stuff pads and grooved discs all round.
Wanting to go to the next stage now.
Thinking: clutch, fuel pump, electric boost controller, then getting a nistune remap.
Would it be worth doing anything else before the remap, e.g turbo and injectors? 350bhp would be a nice goal. Is that a sensible goal??
Advise would be great thanks.
 

shroom

Active Member
All of what you have stated should with a remap see you to that figure so no need to go for injectors etc, just bair in mind that if its the stock turbo its old, and could possibly be put under some strain, but aslong as everything is good and well Ed has got some good results from the stock tubby and jectors.
 

MarkTurbo

Well-Known Member
All of what you have stated should with a remap see you to that figure so no need to go for injectors etc
You'd be lucky to get 350 on standard injectors, turbo, and maf! And greenstuff pads are dangerous with standard power let alone that much :lol:
 

chopper

New Member
I did think from reading on here that 350 on standard stuff would be pushing it.
So we're back to NEW pads, clutch, fuel pump, elec boost con, turbo and injectors before remap. to reach 350??
Not sure what make suspension but it drives good so i'm happy with that. am waiting delivery on strut bars as we speek.
hoping to get hold of a good con used turbo and injectors as i dont use it much.
 

skiddusmarkus

Active Member
If you wan tot stop properly, skip buying new pads and go for a bigger front setup.They usually crop up for around £400 for a used 300mm & 4 pot setup.What clutch have you got in ti now?Instead of just swapping it 1st, you could always put the money to one side just in case.You might be lucky and find your clutch will hold.
For 350bhp you'll only need 550cc injectors which seem to pop up every so often and will be easy for you to sell on if you decide to go for more power.
 
Top