New Bits - Best Place to Buy These Days?

B

billy187

Member
Hi Guys,

Need to order as many of the small niggly new bits as possible for my sunny project such as:

1) Track Rod Ends
2) Ball Joints
3) Front And Rear Uprated Drop Links (Complete)
4) Clutch Slave and Master Cylinders
5) Full Set of all 4 Wheel Bearings

Its almost ready to be built back up from a bare shell now so feel free to add to the list with other bits i should replace now that i have missed.

Please also let me know where you guys have been buying the above from lately as i havent bought many standard bits recently.
 
vss irvine

vss irvine

Well-Known Member
youve got uprated bushes for the droplinks already ;)

ebay seems to be the place these days to get all the stock bits.
although i buy all mine from my local motor factors and use blueprint for as much of it as i can.

i also bought inner track arms and new steering rack boots.
new cv boots can be bought from ebay

ive bought these lately.
water pump
lambda sensor
water temp sensor x 2
new injector seals
thermostat
injector resistor pack
rocker cover gasket (complete)
rear drop links
dizzy cap, rotor arm
new plugs
plug leads
fuel & oil filters
det sensor
oil pressure sensor

let me know if you need links to best place to buy all these
 
PobodY

PobodY

Moderators
Staff member
billy187 said:
Hi Guys,

Need to order as many of the small niggly new bits as possible for my sunny project such as:

1) Track Rod Ends
2) Ball Joints
3) Front And Rear Uprated Drop Links (Complete)
4) Clutch Slave and Master Cylinders
5) Full Set of all 4 Wheel Bearings
.
Click to expand...
I was planning to get my track rod ends off eBay (£7.44 each).
Ball joints I was going to get in new wishbones, but I can see those at ~£5.50 each
The droplinks I usually get from Nissan then put polybushes in when installing.
Clutch slave cylinder I bought off eBay, but the master cylinder was a rebuild kit from Nissan
Wheel bearings I bought off eBay. - £35ea including dust seals and a new split pin, and despite being told I needed a press I installed them with a lump hammer.
 
You must log in or register to reply here.
Top