MAF sensor reading

[goob]

I dida check last night with voltmeter to see what it was at. Im no very good when it comes to that stuff, but i noted down the readings anyway.

On voltage setting, it has the setting :-
600
200
20
2
200m

With it at number 2 the reading was jumping around at approx .025

so should i reground the MAF?

thanks for any help

 

[AJ4]

Use the "200m" scale, you should read less than '9' ( you are reading '25' so it will need to be re-ground.

( On the '2' scale that you measured '0.025', it should be less than '0.009' , which is same thing )

 

[goob]

thanks mate, so i'll solder wire onto the white wire at MAF then run that to the earth point on bulkhead.wether its a noticable difference in regrounding it, i dont know

car seems to run ok but i thought i would check it anyway. cheers again

 

[AJ4]

no worries bud, have a look in the MAF FAQ if you haven't already.

http://bb.gtiroc.com/viewtopic.php?t=33329

Cheers,