Engine Breathers

[PaulB]

Righyo fellas,
im in the process of puttin my gt3071r turbo on, and in doin so im gonna be makin custom alloy inlet pipes.

What i need to know is what to do with the breathers that are attached to the standard induction hose??

Do i put em on me new pipes? Catch tank ? filters? block em off?

Any ideas will be great, should be puttin it bak on 2moro...

Thankin Yooooo

 

[rossdj1983]

block off the one to the inlet, and the other have going to your catch tank mate

 

[PaulB]

is that the catchtank at the front of the car just above the manifold ?

and the one to the inlet is that f at one returning to the inlet manifold ?

cheers

 

[rossdj1983]

yes mate oil separator is just to the right of the ex. manifold.
the pipe that comes off the inlet pipe goes up to the top right hand corner of the rocker, this one can be bunged up

 

[1&onlygti-r]

hi mate i had a gt3071r turbo fitted to my car, hiteq made a stainless indution pipe to fit the 4" intake of turbo to a z32 afm with silicone hoses i can sell you the loinduction pipe with the filter for £200 if you interested, £300 with the z32. check the picture out
http://i56.photobucket.com/albums/g170/pulsardan/094.jpg
thanks

 

[rossdj1983]

or do a diy like me- got the 4" inlet to-

 

[rossdj1983]

but i used the q45 afm instead of the z32 cause its about 10mm wider (and it only cost me a tenner)

 

[1&onlygti-r]

if you noticed on mine were it goes to the z32 it is tappered so you could cut it down to get it to fit the q45

 

[PaulB]

cheers fellas,
think im gonna use a catch tank on the pipework from the rockers, best not to cover them up.
The other one, 30mm dia. i think, iive disconnected it as its the standard dump valve. plugged it off and im using a different one

Cheers Ross