A
antilag
Guest
i cant seem to find it i no there everywhere but can sumone point me in the rite direction please
S
seanleed
Guest
YHM 
A
antilag
Guest
wat a nice feller
cheers geez
cheers geez
A
antilag
Guest
i cant really work it out though lol i need to no
were these are
ig12v
rpm signal
ignition signal
were these are
ig12v
rpm signal
ignition signal
A
antilag
Guest
i just need the ignition signal now anyone?????????
A
antilag
Guest
some one must no were the ignition signal wire is i think its number 36 please help b4 it gets dark
M
Mart
Guest
According to service section
Ignition signal is terminal 1
engine running: 0.3 - 0.5v
engine 2'000rpm: 0.7 - 0.8v
hope that helps,
Mart
Ignition signal is terminal 1
engine running: 0.3 - 0.5v
engine 2'000rpm: 0.7 - 0.8v
hope that helps,
Mart
Is that the same as ignition power?
If so with the ECU plug facing you it's the bottom row second wire in from the right.
Check here to be sure: http://www.apexi-usa.com look at the wiring for the AVC-R I think it's page 13 diagram 3b for the Pulsar, but do check?
If so with the ECU plug facing you it's the bottom row second wire in from the right.
Check here to be sure: http://www.apexi-usa.com look at the wiring for the AVC-R I think it's page 13 diagram 3b for the Pulsar, but do check?
M
Mart
Guest
ignition power is terminal 3
A
antilag
Guest
well im looking at the s14 diagram and the ig12v is the same the rpm signal is the same and the 1 i cant find goes into terminal one on the s14 so it must b the same i'll go and try if i ent come back on the forum just assume im dead
A
antilag
Guest
cheers for your help its all working now good little system and it was on the number 1 pinout :lol:
M
Mart
Guest
Your welcome,
good to hear u didn't blow ur self up
good to hear u didn't blow ur self up