Compressor Gasket

[GTI-R Nath]

is there anywhere in the UK that sells the 3 bolt Compressor Gasket been looking all day for one and only seem to find them in china or usa
[h=1][/h]and before anyone says have you tried nissan, i have and it would be quicker ordering from abroad than from them

 

[JIMMYBACK]

http://www.ebay.co.uk/itm/Garrett-T25-T28-Turbine-5-bolt-flange-Gasket-s-steel-200sx-SR20DET-s13-s14-/390414740362?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item5ae6882b8a

 

[JIMMYBACK]

http://www.ebay.co.uk/itm/NISSAN-200SX-SR20DET-T28-S14-S15-TURBO-ELBOW-GASKET-/130731230168?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item1e703043d8

 

[JIMMYBACK]

Just found a cheap one http://www.ebay.co.uk/itm/T25-T28-PRESSED-STEEL-UPRATED-METAL-TURBO-CHARGER-ELBOW-DUMP-PIPE-EXHAUST-GASKET-/120838254853?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item1c22857105

 

[GTI-R Nath]

There all 5 bolt turbine gaskets,

 

[geoff pine]

Are we talking about the turbo to inter cooler pipe the paper type one i may have one but I'm in sunny Colchester till tomorrow morning . If I have it it will take me two minutes to fined if I have one your welcome to it as I don't have any use for it I might even post it for free as well .

 

[pulsarboby]

nip into a motor factors and buy some gasket paper (heavier grade) and make one, itll take you 5 minutes

 

[j0ff]

nip into a motor factors and buy some gasket paper (heavier grade) and make one, itll take you 5 minutes

good call. Small ball pein hammer and tappy tap tap round the edges.

 

[Fusion Ed]

Got one here. £5inc p&p. TBH though, thin layer of sealant is all you'll need if the faces are as they should be.

 

[GTI-R Nath]

I ordered one from japan this moring before i saw any of the posts, the dilivery cost more than the gasket lol but is a metal one

 

[JIMMYBACK]

Sorry Fella i misread the post:-o but you get the general idea, they are generally found Ebay8)

 

[GTI-R Nath]

Yeah theres one listing for this gasket on e-bay from tiwan, if there were on e-bay i wouldent of asked in the 1st place lol

 

[PobodY]

TBH though, thin layer of sealant is all you'll need if the faces are as they should be.

That's all I'd use; I'm pretty sure there's no gasket on mine.

 

[Fusion Ed]

Yep. Its fine if both sides are machined.