BabyGodzillaGTi-R
Member
Hey guys the car has done atleast 2000km of running in at now its time to up the boost.
Dont laugh at my dumb questions as i'm new to "basic" tuning.
Just want to know if i on the right direction.
I'm running the 1st gen blue screen SAFC.
What throttle position do u set it to? Mine's 25% Lo and 65% Hi
I roughly understand that to tune WOT u just make sure the AFR is ok throught the rev range. I've set it to a conservative 11.7 AFR on the WB.
But urm how do u get the right balance on "part" throttle then?
Any tips to share on tuning something so basic yet sounds impossible to me.
Also how do u guys set the "Dec Air" option? According to the manual its for cars with stalling problems for atmo BOV ( i dont have one). Anyway how should i set it?
Also my car oddly has stalling issues. It seems when i clutch in after crusing the revs drops and stalls. What could it be?
My cars has a full rebuild with oversize 1mm pistons. Run a GTR fuel pump, new Denso IK24 plugs, and cleaned injectors. Checked all the vacuum pipes too.
Funny that when I up the NePoint 1 on lo thorttle to 30% its ok....
Rolling Eyes
I using an AVCR for boost control. Aim to set Lo Boost 1 bar and Hi Boost 1.3 bar.
I somehow cannot seem to get the duty to go into self learn mode where is see the Duty: ****. Is it because it senses its still spiking?
It funny that i need to set the duty to 20% compared to my friends Silvias for 1 bar.
My other concern is how do u set the "gear judge" in "ETC" mode where u dial in some figure for diffent gears? Am i suppose to drive it around in a particular gear? Or just set it to the higest rpm devided over speed for each individual gear?
Also doing a search in the forum.gtiroc.com i dont understand why am i advised to turn of "Gear Learn" option.
Thanks so much for reading my problems and really appreicate your input guys.
Cheers.
Dont laugh at my dumb questions as i'm new to "basic" tuning.
Just want to know if i on the right direction.
I'm running the 1st gen blue screen SAFC.
What throttle position do u set it to? Mine's 25% Lo and 65% Hi
I roughly understand that to tune WOT u just make sure the AFR is ok throught the rev range. I've set it to a conservative 11.7 AFR on the WB.
But urm how do u get the right balance on "part" throttle then?
Any tips to share on tuning something so basic yet sounds impossible to me.
Also how do u guys set the "Dec Air" option? According to the manual its for cars with stalling problems for atmo BOV ( i dont have one). Anyway how should i set it?
Also my car oddly has stalling issues. It seems when i clutch in after crusing the revs drops and stalls. What could it be?
My cars has a full rebuild with oversize 1mm pistons. Run a GTR fuel pump, new Denso IK24 plugs, and cleaned injectors. Checked all the vacuum pipes too.
Funny that when I up the NePoint 1 on lo thorttle to 30% its ok....
Rolling Eyes
I using an AVCR for boost control. Aim to set Lo Boost 1 bar and Hi Boost 1.3 bar.
I somehow cannot seem to get the duty to go into self learn mode where is see the Duty: ****. Is it because it senses its still spiking?
It funny that i need to set the duty to 20% compared to my friends Silvias for 1 bar.
My other concern is how do u set the "gear judge" in "ETC" mode where u dial in some figure for diffent gears? Am i suppose to drive it around in a particular gear? Or just set it to the higest rpm devided over speed for each individual gear?
Also doing a search in the forum.gtiroc.com i dont understand why am i advised to turn of "Gear Learn" option.
Thanks so much for reading my problems and really appreicate your input guys.
Cheers.