afm power fc

N

naz

Guest
hey guys do you need a afm to run power fc, my car dont have one cos its running on a japanese version of the f con pro. so the afm has been taken out.

i wanna push over 400bhp whats the best afm to go for i heard the the z32 wont handle that sort of power.

mapping the fcon cost far too much money compared to the power fc, unless someone knows where to map f con except abbey.

cheers
 
C

cmng

New Member
Fcon V pro ?
you only map it one time.. not multiple time
so make sure all the stuff is ready and only map it

if you runing periodically upgrade.. then power FC is best

since you running MAP sensor.. why you need to change to AFM ?
AFM is restricted .. MAP is pressure.
as long it not exceed the MAP pressure limit .. then it ok
 
A

AJ4

Guest
The Pulsar PFC uses an AFM, can't use a MAP sensor with it. The D-Jetro version of the 200sx is very similar to ours and can use a MAP sensor, but needs a few wires changed round.
 
N

naz

Guest
the v pro version i got is for the japanese market it cannot be mapped in this country according to abbey motors.

so i bought a fcon S thinking it will be the same but abbey say i need a AFM on that version. they advised me to get a AFM from a nissan v8 engine code VH41???

so instead of going back one step i was wondering if i could run power fc without a AFM.
 
C

cmng

New Member
V pro Version cannot be mapped ?

unless they dont pay for the upgraded version for the V pro software
 
You must log in or register to reply here.
Top