a little help needed!!

[jimsung]

Dunno if this is in the right section. I've just replaced the flexible rubber clutch hose (with the metal connections on the ends). Now the 'hoop' end (thats held in place with a bolt at the top of the clutch) i cant seem to match up the hole in the bolt with the hole in the hoop! Are these definately supposed to match up?? And if so any advice on how to do this would be greatly appreciated. It sounds like a pretty simple thing to do but i'm no mechanic!

 

[Odin]

It does not need to match up fella , Just do it up tight it will be fine.

The fluid can get right around the fitting.



Rob

 

[oldaneal]

there is supposed to be a copper washer on either side of it could be one of them has fell off (know i did it when i did mine and wondered :roll: )

n46237a4600 i think if theres one missing 55p