ALLOYS

[Anonymous]

i have a set of multi spoke alloys from my old vauxhal car...was bored last night so tried to put them on my pulsar...they fit on to my 4 threads fine...but the 4thread bolts are a bit smaller than the 4alloy holes...bout 1mm.....would this be dangerous if i put them on !

 

[Fast Guy]

Are they an et49 offset? If they are they'll increase the chances of fouling the caliper. If the holes are smaller the seat for the nuts may not be very suitable and the nuts could come loose :?

 

[Anonymous]

not sure about the offset.is there any kind of plastic rings that could go in to each 4 holes on the alloy so my threads will fit flush in the alloy ??