Adding more boost

S

Stevo

New Member
after fitting my walbro fuel pump can i safely change my boost from 1.1 bar to 1.2 bar
my current setup is this
blitz induction
uni chip
hks svc boost control
ap organic clutch
3" straight through pipe

If the answer is yes, how do i tell my boost control to peak at 1.2 bar as each time i turn the volume button on low boost it goes up but on high boost i get a L flash so im guessing i need to learn the boost control again?? :? help :lol:
 
L

LeeSmith

Member
i suppose it all depends on how the fuelings been set up on the unichip? but i wouldn't have thought 0.1 bar made a difference mate.

i've had that running on mine before, but my ecu is set up for it.
 
S

Stevo

New Member
i think its a svc4 iirc
will check tonight, i got a manual for it but says i need to drive on a empty road in 3rd and it will work out the boost level or sumfink :lol: :?
 
N

nismoboy

New Member
If your still on standard pistons be careful, i would leave it as it is for now and buy a front mount asap, then if u still wanna up the boost get it remapped a raised properly.
 
S

Stevo

New Member
good point, im hoping to sort my standard cooler @ the front. and dump aircon. it all depends on the pipes to do this mod.
 
You must log in or register to reply here.
Top