i have taken me engine out to reseal the timing chain cover and sump pan iam wondering if anyone in central Scotland knows of a good place to take the engine to get this done as i done it myself the last time and it leaked oil bad and iam not wanting too do it again and put the engine back in...
i am just about to take my engine out again after rebuilding it as it is leaking oil from the timing chain cover is it possible to get a gasket for this or do u have too use instant gasket because iam not looking forward too using instant gasket then putting the engine back in and it still...
i have emanage ultimate installed every thing was OK until i updated it too v12 1.3 now my anti lag doesnt work anyone know if u can reset it and start again with standard program :thumbsup:
hi all need to no if u can get gasket sets for the timing chain cover the crank cover and the sump pan as i have put instant gasket on twice now and its still leaking oil from somewhere :sad:
hi all i have a problem will my dump valve and its starting to get at me lol basically it wont work it worked before the engine was out but when i put the standard one on that works fine i have tried 2 different valves and there just the same not opening anyone no why this is
i have just had a small rebild of my engine and was wana double check the timing with u guys does this look ok i am sure its spot on but could be wrong
i have just put my engine back together and put it back in but when i started it there was a major oil leak from the tensioner so i took the tensioner out and replaced the gasket with a new one and now the threads are stripped on one of the bolts would it be safe to tap it and put a bigger stud...
:oops: looking for the adapter piece for a fpr so i can take my standard one off then put the adapter piece where the standard one used to be as Ive got a fpr but o adapter
i have just figured out how to get the launch control to work on the emanage ultimate and i found that if u retard the timing wile its on the launch limiter it gives u a mild anti lag the turbo was boosting at 0.6 bar but iam wondering how safe is this to do
:doh: just got an emanage ultimate fitted and after a lot of swearing and sore heads its finally running but every time i come of the throttle it constantly pops and bangs on the over run sounds shit hot but it didn't do this before the emanage was fitted all the maps have not been touched so it...
my brakes are seriously rubbing on i had this prob before but it was the rear brakes and i got told that was common but today it done it again but was really struggling to go and i never touched the footbrake once and the front and rear disks were roasting so there rubbing front and back now...
i have just bought a front mount and it is goin to be harder than i thought to fit :doh: i was wondering what tool to use or how to cut holes in the wings for the pipes to go through.i hav searched but cant find no info anywhare on this.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.