Search results

Hello mate, I have one and I'm only in Newbury. Want to take the mongoose exhaust too?

I have a pair but you will need to measure what you took off to see if they are the same length.

I have std T28 and at 0.8 bar get 286bhp and just over 300bhp at 1.0 bar. However my setup has changed with a change of exhaust from mongoose straight thru to twin departure and also now have blitz dual ebc. Need to getaway remap.

No luck sorry mate, the whole of the rear seating had been taken out.

I'm going up the scrapyard on Saturday and can see if there is one in the car I'm scavenging from for you.

Can't attend this one as currently painting the car in time for Japfest 2 but might do the next one if you go.

No, I reckon the ones that were on the car were from something else but seemed to fit perfectly. I did strip a car last weekend that had front ones on the rear though but the ARB was standard. Perhaps that was why it was at the scrapyard, had smashed up rear panel.

Just been to Nissan Newbury and they had a set in stock that had been ordered in 7 years ago so RESULT! About half an inch longer than what was on but hopefully shouldn't cause a problem.

PobodY, did you ever get the right sized rear drop links for your ARB?? I'm having real trouble finding the right sized ones (about 15.5cms) compared to what's on offer at over 18cms. If you can remember that would be great. Elton

Yeah, that's what I've found. Not even my local MDC has them. I'll try Nissan. Cheers for info.

http://www.gtirworkshopmanual.com/default.aspx?v=1750 Anyone know where I can order the connecting rod (labelled as no. 15) in the link above of the manual? They connect to the rear stabiliser bar and the bushes are shot. Thanks Elton

Try a motor discount centre if you have one, got all 3 blades for under £15.

Here's the reason for the problem! Broken combination with flattened resistors.

You could be right re wires touching in steering column as I did put in some missing screws thinking it would stop the dash vibrating so much. Will have a nosey at the weekend.is there a relay switch in the steering column for the wipers as well as under the bonnet?

If i said yes, i would implicate a fellow member ;)

Hi All, not sure what I have done but my front wipers have started to turn themselves on and off even when the lever is in the off position. any ideas? Cheers

Pm'ed

Could be just the wire attaching the connector inside the door where it connects at the bottom of the window frame. I have both door looms if they are of any use?

Do any of you run the Dastek piggyback on your ECU as i was having the same problem that if i was stuck in traffic for some time, it would go into limp home mode. Turn the key off and on and its ok again. I had a nistune put in instead of the Dastek and its running sweet as and havent had the...