Search results

  1. JU5TY

    Removing drive shaft from transfer box

    Hi How do you remove the drivers side drive shaft from the transfer box? Doesn't seem to want to come out by simply pulling it. Cheers Justin
  2. JU5TY

    De-Cat Pipe

    Hi all I'm after a stainless 2.5" de-cat pipe, drop me a mail if you're selling one or know the best place to get one from... Thanks Justin
  3. JU5TY

    Ignition barrel and key

    As above I need an Ignition barrel and key...
  4. JU5TY

    Water Temperature

    I’m in the process of running my engine in, I’ve done around 250miles so far, seem to have a problem with the water temperature… When driving on open roads the water temperature is around 80degrees according to the FC Commander, when I hit traffic the temperature rises and rises, I’ve seen it...
  5. JU5TY

    Oil Pressure

    My engine was rebuilt 4 years ago, due to one reason or another it wasn’t finished until the end of last year, it’s only covered 30 miles since then because of clutch issues. My oil pressure seemed a bit low, so seeing that the oil was 4 years old etc I changed it for Millers 10w 40 running...
  6. JU5TY

    Passenger side rear wheel arch trim

    Passenger side rear wheel arch trim in black required. Let me know if you have one for sale.
  7. JU5TY

    Lambda sensor

    Lambda sensor required, I gave mine away a while back... :-( Let me know you have one for sale.
  8. JU5TY

    Rear passenger side wheel arch!

    Rear passenger side wheel arch required, PM me if you have one going, cheers.
  9. JU5TY

    Car Cover

    Anyone bought an indoor (garage) car cover for their R that’s a good fit? If so can I have the details…
  10. JU5TY

    OS Giken clutch problem…

    Started my car for the first time today following a 3.5year rebuild, all went so well with the actual engine, but there is a problem with the clutch… The clutch is badly dragging, it goes into gear when the engine is off, but wont when the engine is on, if you start the car with it in...
  11. JU5TY

    Start up/Run in Power FC map!

    My car goes in to the machiners (who built my engine) Tuesday to be started, I desperately need a start up/run in map for my Power FC. Sam the Dentist was going to write me one and email it, but I can’t get hold of him. I’ve got the datalogit kit, so can use a laptop to save/edit maps etc...
  12. JU5TY

    Fitting a Sunny fog light switch?

    Anyone fitted a Sunny fog light switch? I can get it working so that the fog light switches on and off, but the light on the switch that indicates the fog light is on doesn’t go out! Anyone got any tips as to what wires go where? As in what wires I should spice into 12V/Switched and the...
  13. JU5TY

    Fuel Swirl Pot/Pump’s

    Hello strangers! :wink: Just my fuel system/swirl pot left to plumb in. Couple of questions... At present I have a Sard High flow fuel pump in the tank, is this pump adequate to feed the swirl pot or overkill? I plan to run -8 pipes from the swirl pot to the rail/fpr, then use -6 for...
  14. JU5TY

    Checker Flag

    I posted about this a few months ago, but the thread is now in the member’s general section. Has anyone heard from Checker Flag in the last few months? On my recommendation my friend ordered 2k’s worth of stuff back in April for his RX7, we’ve not had one email reply since then! Found...
  15. JU5TY

    Rad mounting points...

    Can anyone take a picture of the underside of the air con rad? Enough people must have them sitting around… I’m going to use the lower air con rad mounting points to mount my new alloy rad. Are there rubber grommets that sit in the mounting points with two short metal rods on the rad which...
  16. JU5TY

    Oil Separator

    Which pipe goes where on the below oil separator. I assume C goes back to the sump. Just don’t know about A and B, which one goes to the outlet on the cam covers and which one goes to the inlet pipe/filter? Also does it matter if pipe C has a steep increasing gradient before it meets the pipe...
  17. JU5TY

    Headlights

    Quite liked the headlights on this Jap R... So I did the same, but not so sure now, what do you guys think?
  18. JU5TY

    Washer jet Pumps

    Ive now got a tank with a single pump in the boot just to supply the front windscreen jets. Ive done all the wiring/piping to the boot. I removed the front tank, which has two pumps attached, one to supply the front jets, one the rear, ive forgotten which wires fit which pump. For people who...
  19. JU5TY

    Turbo oil return

    What type of piping have people used for the oil return pipe on non stock turbo’s? Also does it matter if the piping doesn’t necessarily flow down more across? i.e. is it under pressure in that it will be forced back into the sump or is it meant to run down the pipe using gravity?!
  20. JU5TY

    Bracing a turbo…

    What’s involves, discuss… RC were saying they need my car running before they can brace it, does anyone know why this is, is it to check for movement etc? What do you brace the turbo to etc…?
Top