ok sorry for the delay i had a quick browse and the bits look good ,just hidden behind a lot of storage which im hoping to get clear off next week
so i have from memory and will double check condition this weekend
drivers side and passenger door
rear boot with...
i have one i will check on condition and upload a photo
also by hatch do you mean the boot with spoiler
this is sold- 2016
sorry for late response
just a quick one
anyone know of either reasonably priced starter motors r a good copany to get mine reconditioned
cars still for sale and comes out from the spray shop this week or next
also to add the photos of the rust is drivers side which is getting repaired, and i also have the towing eye cap, ive just removed it incase it...
so i hope these photos work and people can now view them, the car is now in the work shop getting a new metal arch and drivers side replaced, and...
i know but i dont know how to upload them in a smaller size, but i can email or whattsapp them over to any genuine people.
also to add its now...
hi all so the usual,
Im not sure i actually want to sell but since ive had it rebuilt and mapped for 320 bhp, 2 and a...
is the bonnet painted already? and where abouts are you based cheers
so turns out it was the dump valve, causing the issues.
no not missfiring, i did think maf ill do the obvious things and a full service see if that makes a differnce.
fuel is new as was basically empty...
so it had an engine rebuild and is 4k old. so i doubt a terraclean is required
and what they ve told me so far is it was a static test and let run...
so mot day last week, all good except a few issues.
But the only one that is baffling me is
high carbon and hydro carbon or whatever its called,...
I'm after a passenger side rear caliper in working order
As above the bit with lambda sensor on it
stainless steel one please if they are any good
As already got the cast iron one
ratchet spanner mole grips strong right arm some blood and finally done the,
was sooooooooooooooooooooooooooooooooooooooo much fun
ok so im at a bit of a loss
so im trying to remove my turbo and basically there is one stud that i cant get to and have no idea how its possible...
so just wanting to know if anyone has used any other makes and recommends them as cant find any info on this site. and what they paid
Separate names with a comma.