can anyone help me with a set of front left and rigth lower splash guards?
It's the lower parts that are fitted to the bumper and the upper splash guard (with 3 clips)
Here's a picture where the arrow is in the place where the splash guards have to be fitted.
It will bolt straight on to the standard manifold.
The compressor housing is bigger compared to the 2871.
Will do approx. 480 bhp according to the garrett website.
It's got a 4" inlet.
Turbine side will bolt on too without much problems.
In this topic I posted a pic of it...
Anyone in the south London area got a nice set of 17 inch wheels with good tyres on them?
I'm in the UK this week so if I can pick up a set of
wheels it would be a nice bonus.
Can anyone tell me more about this headgasket?
Is it OEM, aftermarket, thickness etc...
It has 391 stamped on it and it has what looks like 2 notches in it on the side (left upper side in pic 2)
It's been modified to fit an O-ringed block.
The brakes are fine, the noise also doesn't change when braking.
Could it be the driveshaft or the transfer box?
I'll see if I can get the car on a lift in the next few days and get a listen under there, so I can look for the parts when I'm in the UK.
When driving the car I've got a grinding/rumbling noise coming from the middle/front of the car.
It's getting no worse or less if I accelerate or let the car just roll out with the clutch pressed.
It also stays the same if I take a corner.
Any ideas which parts I'll have to take home with me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.